Weidmuller PT 100/3 sig conditioners for current output Manuel d'utilisateur télécharger pdf (Page 2)

1 General instructions

The WAVESERIES signal conditioner PT 100 should only be

installed by qualified staff. The signal conditioner PT 100 should

only be powered up following professional installation.

2 Application

The WAVESERIES signal conditioner PT 100 can be used to

connect PT 100 sensors as well as converting temperature data

into standard linear current signals. The temperature range can

be set by DIP switches on the printed circuit board.

3 Mounting and dismounting

Warning!! Mounting and dismounting may only be carried out

when the power supply has be disconnected. Failure

to observe will lead to considerable damage!

1 2 3 4 5 6 7 ... 13 14

Pas de commentaire

Weidmuller PT 100/3 sig conditioners for current output Manuel d'utilisateur Page 2