Weidmuller Thermo Signal Conditioners for current & volta Manuel d'utilisateur télécharger pdf (Page 3)

3 Mounting and dismounting

Warning!! Mounting and dismounting may only be carried out

when the power supply has be disconnected. Failure

to observe will lead to considerable damage!

3.1 Mounting onto TS 35 DIN rails

(s. Fig. 1)

3.2 Pluggable electronic components for range alteration

(depending on model)

(s. Fig. 2)

1. Remove connector, (depending on model either screw-type

or tension clamp).

2. Press locking clips on both sides of the enclosure.

3. Pull out the circuit board.

Warning!! The circuit board can only be inserted in one

position.

The connectors have been coded by the manufac-

turer, ensuring that they cannot be reversed.

1 2 3 4 5 6 7 8 ... 13 14

Pas de commentaire

Weidmuller Thermo Signal Conditioners for current & volta Manuel d'utilisateur Page 3